Questions & Answers for: lamp cover Cars & Trucks

...lamp?, after taking off covering in hatchback area there doesn't appear a way to get to the lamps but observing from outside car there are 2-lamps over the license plate under a plastic cover but i ...

...cover off to get at the bulb. hi from uk not too sure on elantra but will try to help? if car is hatchback ? lift up hatch and look at the water drain channel alongside lamp? if there are 3x screws? ...

...instructions on how to remove/install headlight assembly on a 1990 civic ex 4 door open the bonnet, unlock the latch for head lamp cover the and remove the head lamp cover and replace the head

...lamp cover (13A656) away from back window glass (42006) and remove rear hi-mount lamp cover. Remove one screw retaining rear hi-mount lamp (13A613). Lift edge of rear hi-mount lamp and pull away from ...

...cover. Pry the liftgate door trim panel (46404) away from the liftgate. Disconnect the luggage compartment lamp electrical connector. Remove the liftgate door trim panel Rotate the rear hi-mount lamp ...

...cover and lens. Remove the retaining screws for the gauge or warning lamp to be replaced and remove the gauge or warning lamp. To install: Place the gauge or warning lamp into place and tighten the ...

...is in the number 4 position and is a 10 amp fuse. This fuse covers the power mirrors, glove box lamp, map lamps and under the hood lamp. The fuse for your dome lights is in the number 14 position ...

cover from inside the trunk to access the lamp assembly. 2. Carefully pull the carpet away to expose the lamp assembly hardware. 3. Remove four nut and washer assemblies and the lamp assembly from the

...push down and it should release, letting you remove the lamp, replace lamp and reinstall pushing the wire back against and up to secure the lamp replace the rubber cover and you should have if ...

...cover is removed, you will see the lamp holder. It is held in place by screws or clips, remove them to take out the lamp holder. Install the new lamp holder: Carefully insert the new lamp holder into ...