...lamp cover only one screw remove it and you will be able to see the back of the lamp 2 screws take lamp out and inspect it , if bad replace it. some sets will have lamp part number on the side also. ...
Question about DLP HL-P4663W 46" Rear Projection HDTV-Ready Television
Lamp Cover Error! I have a HL-P5063W also. It is from August 2004 and few months ago the image started dimming. So i got a replacement lamp and put it in. But then the lamp fan became very nosiy every
...lamp cover switch. Earlier versions used a black plastic switch holder that may break due to improper assembly. The part number for the holder is BP61-01240A. Newer versions use a metal tab attached ...
lamp door cover located I have a Samsung 36inch tv model number TXM3297HF it has shut off by itself a couple of times, I have read on the net that it could be caused by the auto shut off and something
...cover. lamp is held in place with 1 screw. remove screw and pull lamp out by its' handle. install new lamp (do not touch any reflective parts on new lamp) and re-assemble in reverse
lamp cover and then the lamp cover itself. Remove the two screws that hold the lamp to the housing. Pull the old lamp out by the handle. Put the old lamp in a safe place until you can properly dispose
Question about HLP5085W 50" Rear Projection HDTV-Ready Television
lamp cover has been fixed back in place correctly, lamp cover is first thing that you removed from tv to replace lamp, it should be fixed properly after lamp replacement. Are you sure replacement lamp
...lamp cover and then remove the lamp cover. Remove the lamp cover duct by holding the locker and pulling it towards you. Next remove the screw holding the lamp in the housing. Separate the lamp from ...
...cover. [3]. Loosen the lamp by removing the security screw from the handle of the lamp. Though the lamp bulb is visible in the middle of the access panel, the handle is to the left of the panel [4]. ...
Question about HLP5685W 56" Rear Projection HDTV-Ready Television
...lamp cover to change the lamp but the cover doesn't release it seems just to distort the base. There is a hidden screw at the bottom of the lamp cover. These ones are a little tricky. Take all the ...
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions