lamp cover on the back. may be the lamp cover is not seated properly causing the safety switch to not engage all the way, when the lamp cover heats up and expands, it fall away further from the switch
...lamp cover The TV powers off and will not come back on until you take the lamp cover off after you unplug it and power it back on.The power lamp blinks yellow twice every 5 seconds.It work fine until ...
...careful. Tighten the black unit lamp screw with a screwdriver. 5th. Close the lamp cover. Turn the lock/open knob to the right. 6th. Replace the silver front cover. Finished. R. Vega from Puero ...
...LAMP COVER HAS NOT BEEN REPLACED PROPERLY. AFTER PUSHING IN THE LAMP SCREW IT DOWN THEN YOU ALSO HAVE TO REPLACE THE BLACK COVER AND SCREW IT IN AS WELL, I ASSUME IT IS BLACK ON ALL MODELS, THEN I ...
Question about PT-50LC13 50" Rear Projection HDTV
...wont light. Green then Red on power. Orange light blinks in "lamp" area. replaced lamp. Same problem hello The lamp cover is ajar. Firmly replace the cover shaun The lamp cover sensor could be ...
Question about PT-50LC13 50" Rear Projection HDTV
...lamp cover. Pull down the cover toward you. Unscrew the lamp and pull out the lamp horizontally. ✍ The lamp is very hot immediately after use. Never touch the glass portion of the lamp or ...
Question about PT-50LC13 50" Rear Projection HDTV
...lamp cover aswell regards shaun km, I'm having the exact same problem,...lamp housing is secure and so are all covers. From my research the power button will flash yellow when the covers are not ...
Question about PT-50LC14 50" Rear Projection HDTV-Ready Television
...panasonic pt50lc14 located at? Lamp is located under lower front cover as shown in below image, pull that lower front cover and you will see lamp cover tighten with screw. Remove it and lamp is
Question about PT-50LC14 50" Rear Projection HDTV-Ready Television
lamp cover and remove the cover. Next loosen the screw that holds the lamp in place. Pull the lamp out slowly by the handle. Handle the new lamp with a cloth to avoid oils and dirt getting on the lamp
lamp cover screw, first read the caution and warning labels in the lamp cover. Then loosen the lamp cover screw by using a screwdriver. 4. Loosen the lamp unit screw with a screwdriver. Then grasp the
Usually answered in minutes!
627 Questions
462 Questions
520 Questions
406 Questions
457 Questions