...Lamp Cover open 33 Air Filter Cover open 34 Lamp abnormality 35 Chassis Fan failure 36 Exhaust (Back Cover) or Lamp Ballast Fan failure 37 Engine (DMD or Lamp) Fan failure 38 Excess Lamp Temperature ...
Question about WD-57732 Projection Television
lamp cover, the last plastic grille that were removed to replace lamp in TV. TV sense that lamp cover is not either put back or not fixed properly so it wont turn On. Check lamp cover and problem will
Question about WD-52525 52" Rear Projection HDTV
...and the old lamp Hi, Make sure to put back lamp cover in its position securely after lamp replacement in tv. Hope this will help you. Without fixing lamp cover to its place, tv wont turn On.
...on with no picture or sound. What can i do to get my picture back? Did you put back lamp cover after lamp replacement? Make sure lamp cover has been fixed in its place securely after lamp
...lamp cover is properly attached). Call (800) 553-7278 to get a replacement lamp from the manufacturer. Order lamp part number 915P028010. Once you have the replacement lamp, make sure that the TV is ...
cover is removed you can see the lamp which is also held in by two phillips screws, these screws only loosen and do not completely remove from the lamp. 5. after loosening the screws there is a handle
...lamp is cool... There is a small cover on the rear left of the back of the TV (Lower corner)remove those 2 screws. Inside the cover will be the housing unit for the lamp. You simply loosen the 2 ...
...Lamp Cover open 33 Air Filter Cover open 34 Lamp abnormality 35 Chassis Fan failure 36 Exhaust (Back Cover) or Lamp Ballast Fan failure 37 Engine (DMD or Lamp) Fan failure 38 Excess Lamp Temperature ...
...lamp cover. Make sure that it is properly seated and the screws are fasten securely. Lamp cover will engage to micro-switch and make it in closed position. If the lamp cover is not properly seat in, ...
Question about WD-60735 Projection Television
...GOES ON BACK OF TV OVER LAMP? THE TV WAS GIVEN TO ME BUT SOMEONE THREW OUT THE COVER THAT GOES BACK OVER LAMP, AFTER IT WAS REPLACED. You need a lamp cover. Part# 761B478020. cost is about 6 ...
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions