...lamp cover with a Phillips head screw driver Remove the two screws that hold the lamp in place. Remove the lamp unit by holding the lamp handle, then pulling outwards. Exercise caution when removing ...
Question about 60V500 60" Rear Projection HDTV-Ready Television
...lamp door cover then the screws from the lamp housing and pull straight out, do not touch the glass portion of the lamp with your fingers, the oil from your skin will shorten the life of the lamp, ...
...lamp cover is there a replacemnet I lost the lamp cover for my hitachi 60v710 I was going to order this part part#ph33032 but hitachi says part no longer exists so does anyone know of a alternative ...
Question about 60V500 60" Rear Projection HDTV-Ready Television
...our lamp and now the red lamp light is flashing. The tv wont come on. Is there some kind of reset button? Make sure you put lamp cover on securely. Set will not come on without lamp cover in
...replacement lamp pilot light is just blinking Please make sure that lamp box cover is placed back in its position after lamp replacement. If lamp cover is not fixed properly, TV wont turn on.
...lamp cover back on, plugged the TV back in and powered on the TV. However, no picture was displayed. Both the Power light and the Lamp indicator were flashing. Unplugged tv, removed the lamp cover, ...
Question about 50FX48B 50" Rear Projection Television
...lamp has a cover that you will need to unscrew. Most manufactures use a Philips head screw for holding the cover shut. Unscrew the lamp cover. Unpack the replacement lamp. Be careful not to tough the ...
...lamp cover is not properly closed. Disconnect the mains power and carefully open the lamp cover, reseat the lamp and close the lamp cover taking care not to force it. A fault of this type would be ...
...lamp door cover is properly seat-in. It has a safety switch that will engage to the lamp door cover. If the lamp door cover is not properly seat-in this switch will be on open position that will ...
Question about Lamp for Hitachi 60V500A - UX21511m2914533
...lamp cover with a Phillips head screw driver. Remove the lamp cover.4. Remove the two screws that hold the lamp in place. Remove the lamp unit by holding the lamp handle, then pulling ...
Usually answered in minutes!
727 Questions
631 Questions
405 Questions
415 Questions
357 Questions