Questions & Answers for: Dodge Ram 1500 lake temp

Inaccurate temp gauge I have a 2001 Dodge Ram with a 3.9L engine. The temperature gauge will only read the engine temp at idle. Once going down the road, the needle on the gauge will bottom out ...

lake. can you give me some ideas of what it might be or is.Thank you Mike Have you tried changing the temp sensor You might want to clean the throttle body. And the I.A.C. passage in the throttle body

radiator flushed by vacumn system last year, now when the outside temp nears 100 degrees the temp will stay at mid way at 60 mph but when i attempt run faster 65/70 the temp shoots up until I reduce ...

...after it would not start in park. I shifted into nuetral and it started,drove it from home to the lake, about twelve miles, went to park it and it will only go into reverce and seems solid. ...

radiator cool, engine temp = 140 after warm up; temp = 140 degrees; left of radiator cold; lower hose cold; right of radiator hot; top hose hot. Heater works fine. Runs great. IF temp = 140 degrees, ...

2002 Dodge 1500 quad cab 4x4 with 7'6" Meyer snowplow. Trouble keeping truck temp normal on highway. Any suggesttions? your plow is blocking the air flow to the raditor thus the temp change. if it is ...

my 1998 dodge ram 1500 heater wont blow hot air I replaced water pump ,thermostat and radiator blower works fine just no heat. check to see if both heater hoses are same temp when engine is at normal ...

At minus 20* the only way to get heat is to turn a/c to max. and temp as high as it will go.Blows hot air then. Engine temp is good,fan speed is good.Wondering if it has to do with temp control.Please

after my 96 ram 1500 318c.u. gets up to temp. the temp gauge keeps going up. it never has over heated but i dont drive it very far. ive replaced upper and lower hoses, thermastat and radiator cap. Im ...

The temp gauge on my 2008 ram 1500 jumps from normal temp to hot checked engine the temp is fine my heater them puts out cold air and I have no heat if I shut heater off and wait a few minutes temp ...