...250 Venox is a design fault. The prongs (3 of them) on the sliding gear that hook into the slots in the fixed gear giving you 3rd gear ratio, are 2.5mm (two point five) too short. The only possible ...
...Kymco 250 has this weird problem and the shop was no help. Sometimes, not all the time, ill be in the freeway going about 65 for a few miles or so, when i exit as i start to slow down the bike wants ...
...to the inlet manifold, safety device to prevent fuel flow when not in use. If you literally **** on it it will start and run!! USE the VACUUM HOSE / EMISSION CONTROL diagram for the KYMCO Venox ...
...Kymco Venox and everything seems to work fine but it tends to die when its in idle. It has a new battery so Im thinking it may be the carburator. If someone can help me out with this small problem I ...
...Kymco Venox won't start. Bought it a few months ago from someone w. about 20,000 miles on it. Always runs good/never had a problem w. it 'til yesterday. Ran outta gas on the road...put more ...
...kymco venox 250[2010/2011] but with all the problems i have been reading about,should i look more at the 2009 honda rebel 250[if available] or the v-star yamaha 250 with the virago v-twin--i need ...
2003 kymco 250 venox just stopped running,checked for ignition ,no fire to spark plugs. C.D.I. is my first thought. Coils and pulsar usally dont go. I have the exact same issue. Did you solve problem?
...white, engine starts and runs but am worried it might be my head gasket. has anyone encountered this particular problem with a venox 250 I think you're correct in guessing it's a head
Question about 2007 Venox 250
...kymco venox 250cc it broke the rocker arm in it... & not really sure why or what caused it, if I replace the head, will it just go out again due to another problem? Bike only has like 3 maybe 4 ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions
