...expedition will not start. Turns over when I spray starting fluid into air intake.I suspect its the fuel pump. Need to know procedure for changing the pump. First you need to verify that the pump is ...
...expedition will not crank after sitting over night, and if we spray starter fluid it will stay cranked for a while, but will cut off at the traffic light. and restart . I have replaced the fuel pump, ...
...fuel pressure out of pump, check power supply to pump. That way around you know if it is an electrical problem or a pump issue- inside or outside the tank!! Sorry if im a bit general but limited info ...
...fuel pump on my expedition. What a pain. If you have to change pump. Make sure fuel tank is near or empty. 5 bolts hold the strap around tank. Jack up rear of truck take out spare tire to access tank ...
Question about 2001 Expedition
...expedition 2001 eddie b it acts like iy isn't getting any gas we have boosted tried to reset fuel pump button but it wouldn't I guess its ok what is wrong what can we do? acts like fuel pump tried to ...
Question about 2000 Expedition
...expedition wont turn over and I have a new battery and new starter sometimes it sounds like a vacuum Sounds like your fuel pump died. Do a quick check by having someone just turn the ignition key to ...
Question about 2000 Expedition
...Expedition with a 5.4 engine, when I go to crank it, it turns over quite a few times before it finally starts, any ideas? Check fuel system pressure if the pump has a bad check ball or the fuel ...
...Expedition PCM relay keep going bad? A couple of times in the past 6 months my PCM relay has had to be replaced. I don't know what's causing this issue I think that this can be caused by a defective ...
Question about 2004 Expedition
know if it's a short or how to find it. battery keeps going dead , When ? overnight sitting or while driving ? Why did you change the fuel pump ? What engine is in your expedition ? 4.6 L or the 5.4 L
Question about 2004 Expedition
...Expedition has a reset button, it may be worth trying that before attempting to remove the switch. the switch must have 12vd in and out both cranking a volt meter finds that out in must 1 minute. no ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions