...under the dash that the brake pedal lever hits. Sometimes a drivers foot can hit this switch and push it away from its mounts. Just look for a switch that rides the pedal lever when you push down on ...
foot can hit the switches under the brake pedal and knock them out of alignment or even break the switch. This is the same switch which requires you to press on the brake pedal to get the gearshift to
under your dash at the pedal levers. There is a safety switch on the brake pedal which is the one you use when you step on the brake before shifting. Its common for that switch to be hit by a foot and
...under the dash at the Brake pedal lever. The switch that operates the Brake system when you press the pedal to release the gearshift, is either broken or has been knocked around by a foot. This is ...
...under the dash and at the top of the brake pedal lever. It often gets hit by your feet and either gets knocked out of position or broken. Its purpose is to prevent you from getting into gear without ...
...foot is on the Brake pedal. When the switch on the Brake pedal lever is hit by the drivers feet, it can be knocked out of place or broken. Look under the dash at this part and see what you need to
...under load from lean fuel mixture or incorrect timing 4---check the ignition timing 5-- run the engine when it is knocking and remove a plug wire and see if the knocking stops bearings will stop ...
...out and rubbing. Remove the front bottom cover under the upright. There four 8 MM bolts for each arm side. Make sure the four bolts are tight. If the bolts are loose, it will make a knocking ...
Question about DC3050 Computerized Sewing Machine Multicolor - 001DC3050 JAN043-1
foot from the pedal. The first pedal was replaced under my warranty but the replacement does the same thing. When this happens I am able to stop the machine by stomping my foot down really hard on the
Question about DC3050 Computerized Sewing Machine Multicolor - 001DC3050 JAN043-1
...foot and just dislodged it first look under the brake pedal. When the pedal is slightly depressed There should be a switch that is disengaged when the pedal arm moves away from it. Maybe the pedal ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions