REAR WHEEL NOISE/SQUEAK 02 Santa Fe. When reversing i get squeak/rumble from rear nearside wheel, the brakes and tyre pressures are ok. can anyone give me any ideas as to what the problem could be? ...
Question about 2004 Santa Fe
...rear left wheel does not spin 2004 Santa Fe, left rear scraping sound. When on lift and in gear (all wheel drive), all wheels turn except the left rear Take it in for proper diagnosis - that's not ...
...rear brakes emit a LOUD scraping noise & pulses. No noise or pulsing is heard before heavy braking. After heavy braking a few times, this noise is heard if the brakes are feathered or applied ...
2002 Hyundai Santa Fe = ABS, TCS lights come on. Terrible grinding noise when brakes applied. Front and rear brakes/rotors were already replaced. Probably bad wheel bearing
...knocking" noise. any ideas on where to start looking for noise found engines have hydraulic lifters i am used to rockers so this is new to me well theres a few places first would be conecting rods ...
noise from rear of 2002 hyundai santa fe My daughter just purchased a used Santa Fe and while test driving it, there was no noise. The mechanic changed the timing belt and water pump and after picking
Question about 2004 Santa Fe
...noise and see tcs light come on but no change to rear wheels Sounds like transfer case is not being activated. The vehicle is front wheel drive with an electronic activated transfer case to put power ...
Question about 2002 Santa Fe
Knocking noise underneath front end while driving straight Not while turning. Only while driving forward and seems to not make the the noise if I let off the gas. Have the front end inspected by a pro
Question about 2004 Santa Fe
...noise from drivers rear wheel, brief grinding / scraping noise, once every full wheel rotation. Noise doesn't occur when brakes applied or when in reverse. Rotors and pads replaced in last 6 months ...
Question about 2007 Santa Fe
...noise, then it kicks up. Al the brakes are good and new, any help would be appreciated. It sounds like a bad bearing. Either a wheel bearing or differential bearing if it is all wheel drive. First is ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions