engine knocks like diesel All of a sudden my 3.7 ltr Liberty began knocking badly. I took it in for a tune up and oil change since it was due and the problem has actually gotten worse. Power is fine, ...
...knock sensor located and can the knock sensor cause it not to start. get the pcm computer checked first for errors. The 2 knock sensors are bolted into the cylinder block under the intake manifold. ...
Jeep engine is knocking this engine has two knock sensors that plug in under hood back of manifold drivers side the sensors are located under intake manifold that needs to be removed if sensors or ...
I have the p0306 code showing for my 2004 3.7 liter V6 Jeep Liberty. There is a loud knocking/popping associated with this misfire. I have changed all of the spark plugs and the ignition coil for ...
...Knock Sensor 2 Circuit Low Input (Bank 2) Potential causes for a P0332 DTC include (but are not limited to): The knock sensor is faulty and needs to be replaced There is a wiring open/short/fault in ...
...knock sensor circuitry. There are generally two methods that manufacturers have for using the knock sensor. In the first design, which is found in most vehicles, the knock sensor plays an active role ...
...sensor. Also, it keeps dying!!!! why? have the knock and crank sensors checked out Hi. This code has to do with the VSS on the transmission. P0501 is an OBD-II generic code that the engine control ...
how do I install a knock sensor on a 2002 liberty jeep 3.7 find location Explain what a "knock sensor" does? Never heard of one.....
...knock sensor unscrew it ,and screw it back in. why not say why you want to. "symptoms" is the the 3.7L V6? cant answer until you say what engine, is there. 2.4L? here is the ...
Question about 2002 Liberty
knocksensorfor a2002libertyjeep how to replace a knock sensor on a 2002 liberty jeep what's a "knock sensor?"
Usually answered in minutes!
1,658 Questions
839 Questions
768 Questions
735 Questions
633 Questions
