...knock sensor has 1996 mazda millenia 2.3 s.And also the right side bank do not has spark is it possible of knock sensor!!!! thank You The distributor may be broken, it's what provides the electrical ...
...Knock sensor removal and installation-Mazda 3 Disconnect the negative battery cable. Remove the intake manifold bracket. Disconnect the sensor connector. Remove the sensor from the engine block using ...
...knock sensor located it is in the water jacket of engine block, before you change this just thought that u should know that the sensor is likely not the problem, the code only means a problem in that ...
...do I replace the knock sensor on a 95 millenia 2.5 or 2.3? if it is a 2.3, the knock sensor is under the compressor. HUGE job. several hours labor, intake and compressor gotta come off. i HATE this ...
...knock sensor? how much would it cost? my mazda 3 has problem in its knock sensor according to rapide when i have it checked a knock sensor tells the computer to ****** the timing because you are ...
...knock sensor in 2.3liter If you have a 2.3 then the knock sensor location is under the intake,center of the engine block. If you have a 3.0 the knock sensor location is at the rear corner of rigth ...
...knock sensor on 2002 protege5 2.0L need to replace knock sensor not sure were it is located The knock sensor is located under the intake manifold to replace do the followingDisconnect the negative ...
diagram knock sensor location knock sensor location Here's a link to the knock sensor.
...knock sensor on a 2005 Mazda 4 cyclinder Here's a link to the knock sensor,picture is not too good. SAVE 20 GET 10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE Here's another link to a new ...
Question about 2004 6
...knock sensor located? Here's a link to your knock sensor Luis. SAVE 20 GET 10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE Here's a new knock sensor. ...
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions