Question about KITCHEN AID 5 Quart Artisan Series Stand Mixer
...KitchenAid Stand Mixer. The entire top part of the mixer that can lock into place, and what you lift up to remove the bowl, is now tilting too low causing the mixer attachments to hit the bottom of ...
KitchenAid mixer sit too low, which makes the head bump around a lot. How do I fix this? I've tightened all the screws I can see. This sounds like an issue of beater to bowl adjustment, which can come
Question about KHM5TB Classic Plus Hand Mixer
...Kitchenaid mixer at this heading. If this is not your mixer, try again. If this solution has assisted you, please rate it. Good luck! ricardok45 ...
KitchenAid Ultra Power mixer, model #KSM90PSWW, age unknown. The beater sits too low and rubs the bottom of the mixing bowl. Is there a way to fix this? JOE:You don?t say if you have a ?tilt-head?or a
Question about K5SS Heavy Duty Commercial Stand Mixer
Kitchenaid mixer (k5ss lift bowl?) smells hot My Kitchenaid mixer (k5ss lift bowl?) smells as soon as I start using it. It makes an intermittent noise at lower speeds, best described as a groan or low
Question about KSM150PS Artisan Series Stand Mixer
...too low. The beaters are scraping the bowl. Just adjust the screw between the head and the stand (when the head is in upright position) clockwise. This will rise the head, so it won't scrape the
...mixer, head and bowl, with a dishtowel. Turn on mixer to "stir" (or lowest speed). But! Mix only for 1 or 2 seconds. Repeat this, with bowl covered, until flour is mixed in enough not to fly out. ...
kitchenaid mixer seems to have dropped down to low in the bowl Tip the mixer up and look for a screw on the hinge underneath the top part. Turn this screw counterclockwise about 2 turns and the paddle
...mixer bowl as low as it can go with the screw but it is still not low enough Then you are using the wrong beater or bowl for the mixer. What model is it? Newer KA mixers are very part specific. Not ...
Question about K45SS Classic Stand Mixer
...Kitchenaid mixer KSM150 out of the box, head won't lock. Lever won't slide all the way to lock. Locks slightly but still has up and down play in down position and won't lock at all in tilted up ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions