...truck stays in 4x4 your problem is in control box located behind pass.side kick panel check elect. connector for corrosion,if light cor.clean it of it will work fine, if its bad may have to change
pcm location 95 s10 I believe it's on the passenger side kick panel you have to remove the kick panel by pulling screws off then un sanpping the snap buttons to get it off.
does my 1984 S-10 have a CPU? If, so where? actually its an ecm and its either behind the right kick panel or under the dash behind the glove box
...kick panel where the ratchet pedal you push down to apply brake you will see where it was attached [cable/or rod] take a pair of needle nose pliers and move lever it was attached to be careful don,t ...
Where is the fuse for the heater and heater fan in Chevy S-10 2002 Pick-up No manual heater and fan quit DRIVE SIDE KICK PANEL,CHECK FUSES UNDER THE HOOD ALSO
...kick panel on the passenger side for corrosoion. If any posts are broken are burnt they will need to be replaced. have a 2001 blazer push 4 hi button and nothing happens. the light on all buttons for ...
i got a 1985 s10 blazer need to change the emc and i can not find it can you tell me where it is on this vichle? The ECM should be located on the passenger side kick panel or behind the glove box.
...kick panel , then check the bulb of the bad light, with a Meter,, you could have a bulb filament flopping around and it looks to be good , also check that the base of the bulb is clean and has good ...
...find the electrical control module,where do i find it on the engine block,so i can replace it . under dash to the right of the glove box behind the kick panel, there is one screw holding it up in ...
...TCCM. It is located behind the passenger kick panel. A poor design caused water to leak onto the wiring. If there is evidence of water damage, remove the wiring harness, and dry it with a blow
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions