...Kenmore oven is two years old, Model 96113. Original bolts installed at the factory came loose and dislodged from the door handle. Sears Parts assistant said the original bolts for my stainless steel ...
...Kenmore 665 that won't unlock some of the kenmores have the door lock motors in the back behind the large panel slide out an remove panel an pull or push the rod to unlock door if motor is bad for a ...
Question about 40494 / 40495 / 40499 Electric Single Oven
I have a Kenmore Spacemaster model#564-8755380 the handle was falling off and the microwave would not heat after the handle was loss. Could the handle be the problem or could it be the heating eliment
...oven range. Never really use it. Decided it was time to use the self cleaning. It did not work. $280 to put a new board in. 4 months later I went to clean it and again it did not work. The f*^ing ...
...handle on my Kenmore Microwave 80413 has come loose. There are screws available that i can take the dorr apart as it seems I only need to replace the screw on teh bootm of handle. I am looking for ...
Kenmore Electric Range - Door handle Original bolts installed at the factory came loose and dislodged from the door handle.... no problems but this... i can not screw the handle back myself.. i tried.
Question about 96213 Electric Kitchen Range
...to remove the oven door to re-attach the oven door handle...only problem is I can't figure out how to remove the door if its a kenmore,,,,,, try pulling the door open half way tghen lift staright ...
Question about 96213 Electric Kitchen Range
...exist, change the hinges, or close the door with a hammer handle between the door and oven. Place the handle down low by hinge, then push the door closed very firmly to pull the hinge outward a
...to replace the handle. The problem is that the door and seal are treated to prevent radiation leakage from the oven. Threat the inside of the door with extreme care because microwave rays are
Question about 96213 Electric Kitchen Range
...kenmore over the counter microwave #721.80032 that is a 2010 model, and the microwave oven just stopped and doesn't work now, but the exhaust part does. Any ideas about what to look for or even try? ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions