Question about 1750 psi Electric Pressure Washer
...to install the pump guard. The bottle is installed on the water inlet side of the pump. Good Luck, enjoy ...
...for it to work Your unloader valve is stuck in your water pump. Remove it, lube the top o-ring with silicone grease. Then reinstall it. Use pump guard additive to prevent this problem from
...valve in the water pump is stuck. The grease wears away after time. You need to remove it, apply grease to the upper o-ring and reinstall it. Use pump guard in the future to prevent this
...is a injector valve in the water pump that is sticking. Remove this valve, grease the top o-ring and reinstall. Problem solved. Use pump guard in the future to prevent this problem from
the injector valve and apply silicone grease to the upper o-ring on the injector valve. Then you will be up and running. To prevent the problem from reoccuring use a pump guard additive before storing
Question about 2500 PSI Pressure Washer
...Karcher 2400 psi pressure washer Pressure is fine when first started and trigger pulled, If trigger is released pressure does not return. If I pull out the choke it will build pressure but that's a ...
Question about Stratton 020273 Elite Series Portable Gas Pressure Washer
Pump Guard, it works very well and can be assured that your pump is properly winterized. Here is the information on how to use Karchers Pump Guard force air through the inlet and blow it all out works
Question about K5.540 2,000 PSI 1.4 GPM Electric Pressure Washer
Karcher pump guard? CLEAN FRESH WATER IS IMPORTANT FOR THESE PUMPS, I ALWAYS USE A HIT OF ARMOR ALL IN THE PUMP AFTER USE . YOU MIGHT SEE IF IT'S GETTING POWER TO THE MOTOR MIGHT HAVE A BAD GFIC ?
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions