Question about 2500 PSI Pressure Washer
...2-3 seconds and the engine dies. I have removed the piston and spread white lithium grease all over it and put back together and that did not work. I am connected to a garden house and assume that I ...
...karcher 520m i am about to remove the 4 bolts but need to know 1) where can I obtain a new seal? 2) what type and quantity of oil do I use to replace? thanks. small engine shop should be able to ...
Question about 2500 PSI Pressure Washer
2) Used red hot nail to put single hole threw center of top 3) Re- Install tube 4) Took a Manual 8" Multi Sports Ball Air Pump with Inflation Needle and removed the top to poor in Oil then re-sealed (
Question about Karcher K 5.93 M Electric Pressure Washer
...20-30 seconds, then it humms but no compressor then it stops making a noise but works intermitently for short bursts Sounds like a motor problem. It could be that the brushes are worn in the motor. ...
Question about G 2600 VH Gas Pressure Washer
...20 hrs. Pressure dropped 2/3. Was told valve stuck from minerals. How do I get to valve to lube them? Can I download a pump manual? Thanks Does this help? ...
Question about G 2600 VH Gas Pressure Washer
karcher 2500ph pressure washer spill valve has been replaced pull wand trigger pressure good for 3 or 4 seconds drops off for a second or 2 goes back to good pressure for 3 or 4 seconds drops off ...
Question about G 2600 VH Gas Pressure Washer
...Karcher 3.86 electric pressure washer: With everything hooked up, water turned on, it makes a very loud humming noise until I pull the trigger on the wand and then it works normally. But when I ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions