Questions & Answers for: jvm3670 fuse

No Power my wife ran it 30 mins with nothing in it...now no power. Is there a fuse? Yes there is a fuse. You''ll need to unplug the unit, remove the outside cover and follow the line cord and you ...

JVM3670, replace the burned-out bulb with a 120 volt, 20-watt halogen bulb (WB36X10213), available from your GE supplier. To replace the bulb(s), first disconnect the power at the main fuse or circuit

the microwave will not heat anymore...it still runs, but it doesn't heat. It is only 4 years old and $700+ to replace...wondering if getting it repaired would be worth it Might want to check to see if

JVM3670, replace the burned-out bulb with a 120 volt, 20-watt halogen bulb (WB36X10213), available from your GE supplier. To replace the bulb(s), first disconnect the power at the main fuse or circuit

...fuse located for the GE Profile Spacemaker microwave JVM3670? Hello there: if you first remove the power to the unit. then remove the outer cover by removing the screws that are lovcated on the back ...

turns on but no heat. ? is there a fuse we can replace and where is it? A microwave not heating up is caused by one or more of the following - 1) Failed controller board (unlikely if you are getting a

JVM3670, replace the burned-out bulb with a 120 volt, 20-watt halogen bulb (WB36X10213), available from your GE supplier. To replace the bulb(s), first disconnect the power at the main fuse or circuit

...fuse inside the microwave JVM3670. Hello, Thank You for using FixYa. I will be helping you today.The fuse is behind the control.Remove the top screws holding the front top vent cover on then you will ...

FUSE HOW TO REPLACE FUSE unplug unit remove top cover should be able to see it on top of fan shroud or top somewhere

Need help with a power issue. Replaced fuses and control board because it was dead. Power was restored. Re-installed unit but it only worked 1/2 a day and went dead again. Fuses are good. When I would