Questions & Answers for: jumper wire

...jumper wire was for a 5 wire t'stat with 1 transformer, the red jumper actually should have been from R to 1. So you need to trace the wires back to the furnace and make sure they go to the locations ...

...red wire can go on either the Rh or the Rc terminal along with the jumper. If all else fails just put a wire under Rh and another wire under Rc and then wire nut the red Rh and Rc wires all

...jumper wire on the thermostat between the RC and the RH connection for the heating to operate. It is possible that your installation needs this jumper wire installed for the heating to work.Verify ...

...jumper wire. It is a very tight fit to get the boiler wire in that terminal with the jumper wire already there. The boiler wire has already slipped out of the terminal. Do I really need that jumper ...

...jumper wire between Rh & Rc Red wire to Rh or Rc whichever is easier since there is a jumper. This is the hot wire and all the thermostat does is connect to route it to the components needed for ...

...jumper wire was in place. Remove jumper wire? Power Supply went off. Removed the jumper wire, then pressed the Power On button. The Power Supply came on ) Bypassing the Power On switch has nothing to ...

jumper wire and where can I buy one? I need a jumper wire to program a new remote for my 1997 Buick LeSabre. Thank you, a jumper wire is just a wire with a steel connector on both ends that is used to

jumper wire across the GND/BLK and RLY/RED test points. (Ensure jumper wire only makes contact with the designated test points.) Verify that the Relay LED is lit. Remove jumper wire. With the Power ON

...jumper wire ends then two purple wires the same way with jumper wire.then start mower if it dies whenever you try to engage the blades switch 2 ends and replace a flat fuse.for it will have blown.you ...

...a jumper OR what?? where did all the wires land on the old stat? Why would you add a jumper when jumper is already there . Leave jumper and wire exactly like old. If it heat only then it's only 2 ...