...jumper (PSWD) on the motherboard. This will also clear all CMOS settings: Open your casing, on your motherboard. find the CMOS password reset jumper (3-pin) on the motherboard; Remove the jumper from ...
...jumper settings where you connect it (if it's IDE). Also, check the boot order in the BIOS (or setup as it may be called when booting up) to make sure that they computer's not trying to boot off the ...
drive just make sure that the jumper on the back of the new drive matches the jumper setting on the back of the old one (master/slave/cs). The diagram for the jumpers should be on the top of the drive
...open your cpu cover and find the jumper settings near to the the cmos battery. then try to change the jumper settings or removed a cmos battery with a few minutes be sure that shutdown your
Question about Optiplex GX520 Desktop PC - Intel Pentium 4 3.0GHz, 512GB DDR2, 40GB HDD, CDRW, Windo
...no other devices on this cable. When the computer boots up go into the BIOS configuration to see if the BIOS detects the DVD burner, if not then the jumper settings on the DVD burner is not
Question about OPTIPLEX GX150 PIII-1.0GHz 256MB 40GB DESKTOP (PCPIII1000DELL256MB)
...diagram on Dell's site if there is one). If you find 3 pins labeled like that, switch the jumper to the alternate position and then back again after about 15 seconds. Now replace the battery. Start ...
Question about OPTIPLEX 745 PC Desktop
settings are:Locate the 3-pin CMOS password reset jumper on the system board.Remove the jumper plug from pins 1 and 2.Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.Replace the
Question about Optiplex GX60 PC Desktop
...Ya probe quitandole la pila y nada y ademas no veo ningun jumper here's a diagram of your board and jumper locations: ...
...my pc was not running fine 3rd and 4th light lit up at start and nothing more i adjust the pswd jumper to service mode it started. but at the start it shows service mode jumper is installed what ...
Question about OptiPlex 390 DT Desktop Computer Intel CoreA i3 2100 Processor (BPMCKB8D5
...settings Turn off the computer and disconnect the power cable from the electrical outlet. Remove the computer cover. Locate the 2-pin password connector (PSWD) on the system board. Remove the 2-pin ...
Usually answered in minutes!
848 Questions
511 Questions
428 Questions
382 Questions
349 Questions
