Questions & Answers for: Hitachi jumper settings diagram

...jumper settings but here is a site that appears to have them for TravelStar: http://www.ontrack.com/jumperviewer/ If the drive is not showing up in My Computer make sure there is a drive letter ...

since putting an hitachi 250 gig hard drive in to my comp it is causing all sorts of probs! comp wont start up hangs. next time starts up perfectly and after a while in windows get get blue screen ...

...jumper settings for a hard drive are: Cable Select Primary Secondary Cable select means that the mainboard will choose whether to make the drive primary or secondary. Most mainboards today support ...

...jumper settings for a 2.5 Hitachi DK23DA-20F hard drive Hello, I'm installing a 2.5 Hitachi DK23DA-20F laptop drive in to a desktop as a slave drive and was wondering what the jumper settings need to ...

hi where is the jumper to put the hard drive into slave position on a hitachi TRAVELSTAR HTS541080G9SA00 ? I cannot find it Many thanks best regards Hi There are no jumpers to set on a SATA drive ...

...jumper settings of your hard drive. If you are running it on the same IDE cable as your master drive then you need to set up your Hitachi's jumpers as a 'slave' drive. More often than not there are ...

...jumper settings to set this drive as master also do i need to connect it to the end of the cable? thanks Here is a list of the jumper settings: ...

...jumper settings listed there. Some may be ambiguous, my last one offered the option of Master on / off. (Jumper in position 1 for on, no jumper for off) The off in this case was of course slave. The ...

...settings for plastic jumper location is usually printed on the top of a hard drive IDE-0 means Pri master IDE-1 means Pri slave IDE-2 means Sec master IDE-3 means Sec slave single or master ::::: ...

...jumper settings. If you have a SATA drive, there ARE no jumpers. If the drive is a PATA, then if it's connected with another drive or cdrom, then make the cdrom 'slave' and the disk ...