jumper settings for your model motherboard with detailed pictures to go to http://support.gateway.com/s/MOTHERBD/INTEL/m00061/M0006126.shtml Goodluck Please Dont Forget To Rate, Thanks :D I am looking
...jumper to master on the DVD you put to the top in the bay. If you have two drives on one IDE cable the drive at the very end of the cable is always set to master. The drive in the middle of the cable ...
be set to master drive, if not just make sure the jumper is in the master slot. A small diagram should be on the hard drive. Then make sure you connect the hard drive to the end ribbon cable connector
...jumper pin found on the one side of the HDD, there should be a diagram on the top of the HDD which will show you how to change the drive from a master to a slave. Then just check that all of the data ...
settings or auto hard drive setup in it. I'm not sure about the GATWAY but in most computers there is a bios battery. In the past I have worked on Gateways that had the mother board well marked or
Question about 505GR PC Desktop
...jumper settings. I lost my cheat-sheet diagram and need to determine which wires/cables go where... Look for a make and model number and version number on the motherboard, gateway use various ...
Usually answered in minutes!
697 Questions
487 Questions
417 Questions
330 Questions
336 Questions