need jumper diagram for motherboard i have a dell 160 l i need the jumper diagram for the mother board lay out i nstaled new 80 gig and new xp pro and wont boot up Hi, Check that the hard drive is set
...support just about any IDE dvd rom or combo. When replacing the cd drive just make sure that the jumper on the back of the new drive matches the jumper setting on the back of the old one ...
Question about OptiPlex GX520n PC Desktop
i remove the battery during 15 minutes and nothing happen, i reset the jumper and nothing happen. the request for a password still there nay aother sugestions? i would greatly apreciate them. well you
...removal of battery didnt work Look closely at the motherboard, for 3 gold pins in a row, with a "jumper" between two of the pins, say pin 1 (end) and pin 2 (centre). Turn the computer off. ...
...is necessary to change the boot order to run BartPE from CD and do an image backup). There is a jumper on the mainboard called PSWD1, which is set (shorted). Remove power cable from PC (CMOS ...
...Please rate me if this solution works for you there should be a jumper on the motherboard that you can pull off and reset the bios password on it. Once you reset ...
Question about OPTIPLEX 745 PC Desktop
...steps to reset a BIOS password and clear all CMOS settings are:Locate the 3-pin CMOS password reset jumper on the system board.Remove the jumper plug from pins 1 and 2.Place the jumper plug on pins 2 ...
...my pc was not running fine 3rd and 4th light lit up at start and nothing more i adjust the pswd jumper to service mode it started. but at the start it shows service mode jumper is installed what ...
...what i do now. You have to reset your BIOS. 1. On the motherboard near the battery you will find a jumper. Put the jumper to cross the pin number 2 and 3. Turn on your PC. Wait 3 seconds. Remove the ...
Question about OptiPlex 390 DT Desktop Computer Intel CoreA i3 2100 Processor (BPMCKB8D5
...computer cover. Locate the 2-pin password connector (PSWD) on the system board. Remove the 2-pin jumper plug. Locate the 2-pin CMOS jumper (RTCRST) on the system board. Move the 2-pin jumper plug ...
Usually answered in minutes!
848 Questions
511 Questions
428 Questions
382 Questions
349 Questions