Questions & Answers for: Maxtor jumper

...of my main harddrive in my pc and use the 500 gig maxtor as an external storage. i tried with no jumper and my computer did not recognize any new device being connected so i bought a jumper and ...

slave harddrive jumper settings i need to know what the jumper settings are for a Maxtor harddrive. I want to make it a slave in another system. I just need to know where the jumpers need to be placed

jumper settings current backup hd has jumper on top/bottom of #1 pinm abd jumper from top of #2 to top of #3, had been working as backup to c: drive, I want to make it as master. Where can I find a ...

i need jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on ...

5T020h2 jumper setup No jumper is used on the J50 pins, when using the Maxtor 5T020H2 IDE harddrive, as a Slave harddrive. In otherwords do not use a jumper on any of the jumper pins. This is a PDF ...

I want to add another hard drive and need to know how to set the jumpers on my maxtor 90645d3 please help.ty if you want to boot from this drive, please set the jumper to the master position. if this ...

jumper settings for slave drive model 33073u4 30 jumper settings for slave drive model 33073u4 30 gig hello go to this link.. it will illustrate jumper setting http://sysdoc.doors.ch/MAXTOR/diamondmax

how the jumper setting is done for maxtor n256j50 If this is an IDE/PATA hard drive then the jumper settings are marked on the circuit board. MA = master SL = slave CS = cable select If this hard ...

What is the jumper pin placement to make a slave of a DiamondMax Plus 9, 80GB hard drive? The manual is linked below and section 3.3.1 covers jumper settings. The slave setting shows the park position

Jumpers Serttings on Quantum HD Where are the jumper pins and what are the slave settings. Only jumper I found has ..CS..DS..and SP. Right now the jumper is on the DS pins. Thanks! Nick CS = Cable ...