Questions & Answers for: juki bobbin tension

...Juki TL-98Q Loading the bobbin into the bobbin case: Snap in the bobbin case latch, and put the bobbin into the bobbin case so that the bobbin runs clockwise. Passing the thread through the **** of ...

...bobbin stitch is too tight on my Juki DDL 8500-7, how can I fix this? Hi LJ, Look on the bobbin case, and see if there is a small screw. Usually that is the tension of the bobbin. You can adjust that ...

...juki first clean bobbin case loosen thread tension screw and clean under tension spring, hi pressure air is the best. its important to clean under tension part because material builds up and does not ...

...Juki tension right Lu 1508nh which tension is wrong if thread is bunching up under material increase the tension of the needle thread if the bottom thread is loose then increase the bobbin thread ...

Juki 2010Q and bobbin tension try this link for a manual, it should have information in it about the tension Juki TL 2010Q Parts

...juki tension top and bottom loose,top tension mechanism tight what do i do? Remove the thread from the machine. ALWAYS RAISE the presser foot and re-thread from the beginning. Verify that the thread ...

...JUKI DNU 1541-S? hi sally. When the bobbin thread shows on the right side, the needle tension is too tight or the bobbin thread, too loose, as shown in the middle drawing at right. When the needle ...

...bobbin for juki tl 2200 qvp According to the manual (pg 20), it appears the bobbin turns clockwise in the bobbin case. So when the bobbin is loaded and the thread pulled, the thread direction goes ...

lighter weight thread will affect the bobbin tension. Otherwise, perhaps the bobbin case is worn. Look for a replacement bobbin case. http://www.sewvacdirect.com/juki-bobbin-case-fits-tl2000qi-tl2010q

...Juki 2010 TL-18QVP Haruka Just over a year old. Just started this problem. I have changed the needle and the thread type to no avail. Someone told me to turn the sub-tension knob, which I did but no ...