Question about 9120 Computerized Sewing Machine
small adjustments to change the contrast. Have your machine on while making the adjustment. Tools needed: #1 phillips, #2 phillips and I used a razor knife to remove the button covers
sews good on top but balls up on bottom. Check that the thread is tight around the bobbin. Make sure that the bobbin is in the right way around - the bobbin thread should double back on itself coming ...
BALL BERING HAS FALLEN OUT THE SEWING MACHINE HAS STOPPPED INDEXING TO THEE PROPER NEEDLE POSITION AND A SMALL BALLBERING HAS FALLEN OUT. THE REPAIR GUY HAS SAID IT WOULD BE AS MUCH AS A NEW ...
High pitched noise while stitching High pitched noice when sewing Stop using the machine, it Needs to be tuned up and adjusted. Have it tuned up by a experienced repair technician.
Question about Memory Craft 3000
...machine have a belt? Check your owners manual for replacement. A high pitched squealing noise on a Janome MC3000 is often caused by a dry idler pulley either on the motor belt or the timing belt. ...
Question about Memory Craft 3000
...machine. It has a high pitched alarm and all LED lights are blinking. What is going on? Check the troubleshooting section of the manual. Otherwise, it would probably be a good idea to take it for ...
...machine. ALWAYS RAISE the presser foot and rethread the top thread. Test straight stitch. For fraying thread, there is either a burr somewhere in the thread path or the needle is not correct for the ...
Question about Memory Craft 3000
...machine from balling up on bottom 9030 Nesting of thread on wrong side (bottom) is usually top thread tension too low. To be sure which thread is nesting try test sew with different color top thread. ...
Question about Memory Craft 3000
...Lily and my bobbin won't came off the rewind Some have a small spring loaded ball bearing on the shaft. Give it a shot of WD40. Make sure you fully remove the arm that helps the thread run
Question about Memory Craft 3000
...ball is working ok. Before this I noticed the machine would 'reset' whenever I used the reverse button. Do I have a computer issue? The pedal is not activating the up / down motion of the needle, ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions