Questions & Answers for: Singer jugs small ball pitching machine

Singer 7442 Bobbin Will not wind Whenever I engage the bobbin to wind, and press the foot switch, it immediately locks up and all lights light up. To get it to do anything but blink, I have to flip ...

warning tone? When I turn on my machine the stitch selector light flashes at 88, all the stitch selector lights flash on and off, and the machine emits a high pitched beep. What's going on and how do ...

...small hoop selected on the computer but the machine thinks that the large hoop is selected. How do i fix it?? Before attaching small hoop, turn on power switch to move the carriage to embroidering ...

thread balls up in the bobbin/singer sewing machine, also thread thread balls up in the bobbin-singer sewing machine? thread is too tight-how do you loosen tension? The balance stitch control on this ...

have a singer fashion mate sewing machine and the thread just keep getting balled up under the material and it won't sew and I get error messages on the machine have a singer fashion mate sewing ...

How do I grease the ball bearings on a Singer Futura xl-400? Mine has been locking up, although I get it to go - after cleaning and oiling- I've read that the ball bearing weren't properly greased on ...

...machine. It has a high pitched alarm and all LED lights are blinking. What is going on? Check the troubleshooting section of the manual. Otherwise, it would probably be a good idea to take it for ...

E4 code on singer 7285Q machine machine turns on but when I turn the knob and needle goes up I get a high pitched beep and E4 code on display Search for: Make Model E4 error code

...machine from balling up on bottom 9030 Nesting of thread on wrong side (bottom) is usually top thread tension too low. To be sure which thread is nesting try test sew with different color top thread. ...

Singer 7422 has a high pitched whine while sewing. How can I fix this before it becomes a problem. Re: High pitched noise on computerized machines? UPDATE in new post (posted on 3/4/14 7:59 AM) I ...