...Flashing red light usually means low batteries. Check the batteries after charging all night with a volt meter through the charger port you should read 26-24 volts dc. If you get a lower reading and ...
POWER CHAIR, THE LIGHTS THAT INDICATE THE STATUS OF BATTERY BLINK ON AND OFF (REGARDLESS OF BEING FULLY CHARGED OR NOT) AND THE CHAIR WILL NOT MOVE. SOMETIMES, IF I SMACK THE ARM OF THE CHAIR AND TURN
...Jet 3 ultra power wheelchair...after charging it up I turn it on and the red light is flashing and it makes like a clicking sound when i try to make it go forward..cand you please advise? bobby The ...
...jet 3 has been sitting for 6 months, will the joystick light up when the onboard charger is in use. When I plug the onboard charger in the altameter raised to 3.5 and after charging for 12 hours drop ...
low battery, the GC is in Lock Mode, etc. If the GC is in Lock Mode push the joystick forward until it beeps and then pull it back until it beeps. Release it and the controller will sound a long beep.
...on (lights or hum), charger works on another chair (tough to try at home), etc. Some chairs have a fuse or two in the path that can pop. 3. One or both batteries is defective. Unlikely but
Question about Jet 2 HD for 350 lbs, Power Chair, Wheelchair Scooter Wheel Chair
...Jet 2 HD www.pridemobility.com. 3. TABLE OF CONTENTS. sometimes the batteries for powerchairs sit on the shelf for quite some time and can be low on charge. I would recommend if you have a voltmeter ...
Question about Jet 2 HD for 350 lbs, Power Chair, Wheelchair Scooter Wheel Chair
...Jet 7 comes equipped with a VSI controller. The VSI controller will flash a code via the battery condition meter LEDs if a system fault is detected. # OF LEDS CODE CAUSE POSSIBLE SOLUTION One red LED ...
Usually answered in minutes!
356 Questions
246 Questions
187 Questions
140 Questions
159 Questions