Questions & Answers for: jeep gear shift problems

...Jeep CJ7, Gear shifting / Linkage problem In a 1984 Jeep CJ7, Shifting into third gear, the linkage is sticking, or not going into gear at all. The gear shift lever has been replaced which has ...

...gear. 02 jeep liberty a/t won't shift into 3rd or 4th gear. revs engine like it is in nuetral. have to put it in 2nd gear to drive only can go 35 mph. fluid level is good and not burnt. Help? Ratio ...

...it to reverse to avoid any grinding or problems shifting into reverse...this isn't a problem just a poor jeep design by not installing an extra gear to eliminate this grinding or shifting ...

...gear again . its a 98 jeep wrangler 4 cylinder 4 weel drive and 5 speed manuel trans. the cluch seams good but a frend said it might be the presure plate is getting old !!!! is he right or is the ...

...gear The Jeep will no longer shift into gear and is completely frozen. This problem occurred as I was driving in third gear. There are over 200,000 miles on it. The transmission fluid level is good. ...

...Jeep Cherokee Gear Grinding & 4WD Whine sound I own a 2000 Jeep Cherokee Sport (Automatic). I have been experiencing 2 problems with it: 1. When acelerating from a stopped position, it feels like ...

...jeep grand cherokee laredo that runs and drives fine but it has a problem down shifting constantly, when starting off from a dead stop it doesnt want to shift into a higher gear right away and then ...

...jeep wont shift out of passing gear unless i let if the gas passing gear runs all the way to rev limiter... wont shift unless i let out of gas try checking your transmission fluid level , low fluid ...

...Jeep Wrangler YJ - manual 4 WD end of October and past 2 days have had probs with shifting gears. It freezes and won't move. Got it shifting yesterday, this morning same thing - won't shift properly ...

Jeep to shift into gear nothing happens when I move the shifter in and out of gear until I go to shift it into park it makes a sounds that like the flywheels engaged so I put it in neutral shut it off