Questions & Answers for: MTX jbl stereo

Audiobahn A 18001DT when i installed the amplifier by putting the ground, remote, and power to the amp,and the rca cable in the input.. the amp turned on, even the lights, but there wasnt no sound ...

carlos I will buy a MTX thunder 81000d but would like to know so I will lift the woofer JBL 4000watts w12gti i have a 81000d for sale for 250 dollars car money still in perfect condition i am pushing ...

amp Can installing a car amp damage the factory stereo? if it has the cable slots in the back it shouldnt

why do my mtx 8100d amp keep cuting off wrong wiring for the speakers. to low of an ohm load so amp is going into protect mode. rewire to 4 ohm stereo.

wont power up I have an elite 801d that wont power up. I dont have a cap., i just run from battery to to the amp. The fancy lights flash, but the amp itself wont power up. neither the protect light or

I have hooked up my subwoofer and amp to my factory stereo in a 2011 camry. My power wire is hooked directly up to my battery, my ground to the chassis and my remote to my fuse. I have my RCA wires ...

...JBL stereo and CD player That car has a factory amplified system,,,,,BEST and EASIEST solution is go to METRAONLINE.COM,enter vehicle information to buy amp interface harness.no more than $50.00 at a ...

getting a blue light but no bass from sub woofers, hook up correctly. check ur rca jacks make sure there connected also on stereo make sure subwoofer setting is on and turned up,bass,fader etc...

How to connect a MTX 2 channel amp to Delco stereo with no RCA outputs. What do i do? Get a speakers to line input adapter and that will do the trick.

I have a mtx tunder series 942 when you hook it up the red light comes on I have the best wire and have checked everything the amp is old school it does have a fuse on it I have one on my power line ...