...control on cd deck, Audio cables are connected to amp and deck, Fuses are good, idk what else could be wrong. It is a 94 mustang gt. It has 2 factory amps in the back and i unplugged them to see if ...
...2 jbl ceon bpx 1100's would kill it, im thinking if i should have a similar enclosure built but for two solox 10's and use one jbl amp for each solox 10 insated if two jbl crown 1100's for one solo x ...
...2 years ago. A month after installing it the LH channel went out. I sent it back to Hi-Fi Sound Connection (WOULD NOT RECOMMEND!!) for warranty claim and two months and many, many phone calls (Don't ...
Question about KX800.2 Car Audio Amplifier
NEED TO REPLACE CROSSOVER, BASE BOOST AND GAIN CONTROLS THE POTS ARE NOISY AND CLEANING DOESN'T HELP. Locator #'s VR1, 2 and 3 the pot #'s are on the sides of it and u can just find another with the ...
...control ) you can still here the voice coming out of woofers. 2 12inch. l7`s dual 4ohm. i had 1 a few yrs. back and i remember the module had 2 switches on for high and low? no u turn it completely ...
...coils it is a 2 ohms sub and hooked up to a jbl gto75.2 bridged and is making a poping sound. . also the sub is in series wiring try running in parallel if it doesnt stop tan you have a loose ...
Question about ZR600 Car Audio Amplifier
...control both amps or do i have to use a splitter on the rca wires out of the crossover the crossover is a 2 way. i will be using 2 zr600s for my subs and a zx460 for my components. If you use the ...
Question about CVR10 Car Subwoofer
2 of the control to stop the sub if you run it in two ohm. You'll blow the works up if any part of this equation isn't up to the task of a 2 ohm load. If your budget, space allows, run it in 4 ohms at
Question about CVR10 Car Subwoofer
JBL Is a 2 Ohm load I believe.
I ran through the maths...
Series parallel with the 4 Ohms in series in parallel with the 2 Ohm gives you 1.6 Ohms
2 x 4 ohms in parallel with a
...2 seconds then fades out. Anything I can do to check on? I also have an audiophile bass knob with a 3.5 jack on it. Anyway to splice it and install internally to control bass up front if I can get it ...
Usually answered in minutes!
174 Questions
102 Questions
72 Questions
42 Questions
48 Questions