...sewing machine and when I looked at it, I see that the shuttle driver is not in the same place on both machines. Help! Hi i have a Janome 350E thread got court undert the needle plate so i cut the ...
...Janome 2041 the needle still wont go up and down Okay, so there is a jam. Take out the bobbin case and the hook. Remove the bobbin from the bobbin case if you haven't already. Try and turn balance ...
janome mylock 634D overlocker mylock 634D overlocker, while sewing it jammed. i have removed the needles and threads. still jammed. the wheel{large knob} on right hand side of machine that lifts the ...
sewing machine yesterday and couldn't turn the hand wheel or get the needle to move up and down. I cleaned out the bottom of the machine and tried to move it but it was still stuck. Any advise? Thanks
Question about Memory Craft 9000 Computerized Sewing Machine
...Janome MC 9000 To calibrate the touch screen 1. Turn off 2. on Sewing arm above needle there are a series of buttons 3. Hold down bottom 3 buttons 4. While holding turn on machine 5. Using scribe 6. ...
Question about L-344 Mechanical Sewing Machine
...needle and now it wont drop back down. How can I lease the foot so I can use the machine. The lever does nothing needs to be oiled probably, might be gummed up if machine hasn't been cleaned/oiled ...
Question about L-344 Mechanical Sewing Machine
...it is most like one or both of the first two options mentioned. In any case, it would probably be best in this situation to take the machine to a reputable sewing machine repair shop in your
Question about MB4 Four Needle Embroidery Machine
Janome MB4 wont sew breaks threads really bad? I have had this machine for 3 yrs and it has been a nightmare it has never worked right it breaks Thread has never broke a needle and I have completely ...
Question about MB4 Four Needle Embroidery Machine
...janome 8002dx but i cannot get the hand wheel to lock back in position so the it moves the needle shaft up and down to sew any help grateful thanks I have tried to tighten the screw in the middle of ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions