Questions & Answers for: Toyota Camry how jack lift

Question about 2001 Camry

1 Answer

...jack to lift the hub assembly back up to mount the strut.......Once you have basically disconnected everything from your hub assembly and it is hanging/moving up and down freely, (make sure you don't ...

Ad

...jack under the lower control arm, or if it won't go under on a frame rail and lift from there. You may need to use some blocking to get the car high enough if you jack at a frame rail. Jacking on the ...

Ad

...jack TOO LIGHTLY LIFT WEIGHT OF ENGONE OFF OF BOLTS SO YOU CAN UNSCREW THEM. Two pumps of the jack should do it.Double check all new items with old ones MAKE SURE THEY ARE IDENTICAL ESPECIALLY ...

Question about 1995 Camry

1 Answer

...jack up the rear just in front of the rear tire you are changing. (don't lift off ground completely yet). Using the lug wrench (also called a tire iron) break loose each lug nut. Finish raising the ...

...all bolts taken out. Place a jack with suitable protection under sump so as not to damage sump and lift just a little to relieve just enough tension to remove through bolt onto body....Regards ...

Question about 2000 Camry

1 Answer

...Lift the car with a jack and place jack stands under the frame of the car. Block the rear wheels to prevent the car from rolling backwards. Locate the starter and remove the wires connected to it. ...

Question about 1995 Camry

1 Answer

...Lift the front of the Camry with the jack. Put jack stands beneath the chassis to support the weight of the car. Take off the front wheels with the tire iron. Unbolt the plastic apron seats on the ...

Question about 1991 Camry

2 Answers

...lift to access the bottom of the car, and a transmission jack,dont attempt it. Taking out any front drive transmission is a BIG pain in the ****! However, it can be done in your driveway or garage ...

lift the engine but do need to support it with an extra jack.You will need Chasis stands200kg trollry jack with approx 28-30mm spigot.(Weld a 7/8 socket in the middle of a plate just big enough as the

...be fine and strong enough IF THIS WILL BE A JACK YOU USE OFTEN I WOULD GO FOR A 2 1/2 OR 3 TON.THE LARGER JACK WILL GIVE YOU MORE LIFT . YOU DO NOT WANT TO OVERLOAD A JACK AND ALWAYS USE ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1995 Toyota Camry
1995 Toyota Camry

1,828 Questions

1994 Toyota Camry
1994 Toyota Camry

1,753 Questions

1998 Toyota Camry
1998 Toyota Camry

1,565 Questions

2002 Toyota Camry
2002 Toyota Camry

1,303 Questions

1996 Toyota Camry
1996 Toyota Camry

1,134 Questions

Manuals & User Guides

Loading...