i always recommend using a lift kit for safety but, you can use a hydraulic floor jack to lift as well. they are really strong and sturdy. i would recommend using one hydraulic floor jack on each axle
...to take trans. inspection cover lift motor at least 5 or more inchs and hard to tell what else. what do you think am I close or is there more?!!? thank you! you may have to jack the motor up a ...
...jack to support the door. Reverse to install.Oh & the door panel pops off the bottom but you must lift it straight up to get it off,otherwise you'll break all the door panel hold downs & ruin ...
...lift or jack stands check all halfshafts, u-joints and fluid levels It is not supposed to be in four wheel drive on dry road. The slight sifferences in the two axles cannot be compensated with ...
Question about 2002 Dakota Club Cab
...they all want money. Can anybody direct me to a site or explain to me how to locate? Thanks, Dan Jacked up or on a lift or over a ditch look at the car from the buttom after the air has been run ...
...jack the truck up so tire are off the ground then get and 3 or 4 foot pry bar or strong pipe and put under tire lift up on bar if the tire moves up and down replace balljoints of not check for bad ...
...lift from up top. Support the engine then unbolt the mount from the engine raise the engine unbolt from frame then pull the motor mount out. Put the new one in reverse of taking out. Take ex stream ...
can not find jack pop up the back seat ,, Grab the front of the back seat and lift upwards, it will lift up towards the back of the seat and makes getting the jack out easy
jack stands as you have to go under the vehicle and apply some force loosen of the lh bar and twist it in an anti clockwise direction and install it with this tension ( use stilsons) now do the rh bar
Usually answered in minutes!
1,021 Questions
870 Questions
712 Questions
723 Questions
618 Questions