Questions & Answers for: isuzu trooper 1996 check engine

Isuzu´s (pre 1996) have a different OBD system than the OBDII. The codes are read out from the check engine light flashes after you connect together the appropriate connectors that are under the dash.

...Isuzu Trooper after the check engine light came on. was due to a catalytic converter. still running smoothly & was told it would probably take a while to affect anything. I wanna fix it now ...

1996, engine light on, 4wd light on, replaced aulternator, volts drop when step on gas, still looking for the system with the ground in it. any ideas? Check the blue relay in the engine bay fuse box, ...

that is connected to the nearest fender to the battery. After that check the braided uncoated wire that comes from the intake manifold on the upper engine towards the rear and connects to the firewall

isuzu rodeo LS: Revs high sometimes then revs low to the point it stalls. goes back and forth , won't maintain a level idle. I have to press the gas pedal so it won't stall, so either im stalling at a

...Isuzu Trooper LS, check engine light came on so I checked it with a scanner and it said generic code PO 133, which is a slow response, or slow switching so I put an oxygen sensor on, check engine ...

1996 Izuzu Trooper. The "Check Engine" light is "ON". What are the problems with the engine? Please advise! The PCM has the answer to that. It is just telling you there is an issue

p1442 isuzu 1996 check engine light on and the trouble is at code p1442, my car is isuzu Trooper LS 1996 its g-sensor located at under chassis rear passenger near gas tank

why does my idle not run smooth and engine l not rev up on my 02 trooper Is Check engine light on? If so you need to have a OBDII/EOBD test ran for code identification.

...Isuzu Trooper automatic 3.2 liter dual overhead cam with driving and it just died wont start Is the timing belt okay? Fuel? Oil level? Did it make any noise when it died? Smoke?
Some good info on ...