Questions & Answers for: ironing board wont stay

Question about RX-V995 Receiver

2 Answers

...wont turn on all you hear is a little click and the fan will kick on for just a second. Whats wrong?? The solution is to replace the main power relay. I ordered a replacement relay from Vance Baldwin ...

Ad

...board immediately around it. Warm up the soldering iron and get the solder ****** ready. Heat up the solder joint while removing excess solder with the ******. Once the transistor and capacitor are ...

Ad

Question about Evo N600C PC Notebook

1 Answer

...wont come out of my speakers unless i put a 3.5 mm headphone set halfway or 3/4 of the way in the jack it will go to the speakers but only one side. with headphones and speakers hooked up to the jack ...

...wont stay off settingings mode keeps going back to settings for no apparent reason I fixed a Phillips 37" TV that was doing this by re-soldering the wire/pin joints on the button board (side of TV). ...

Question about Playstation 3 (PS3) Console

1 Answer

...wont stay on it keeps going on standby If your unit is blinking a red light when it turns off this is known as the yellow light of death (ironic i know because it blinks red). This can be caused by ...

wont turn back on whats the problem with it The most common problem found on FixYa for Audio Video Receiver's is: My receiver say's "Protect" or turns on then off. What's wrong? Seven times out of ten

Question about VSX-515 Receiver

1 Answer

...wont stay running. wondering if its something to do with the carborator or idle? Help The 1993 is fuel injected and they had a very common problem with the computer. There is a capacitor inside them ...

Question about TXN3275HF 32" TV

1 Answer

...wont turn on. I removed the back panel and the fuse is fine. there is a constant "clicking noise" coming from a large vertical cylindrical black unit with thick red and black wires coming ...

Question about Inspiron 15R Notebook

1 Answer

board or motherboard? I am working on a laptop for a friend and it wont turn on at all, and when the power cord is plugged in the light on the charger block (known to work and still does) goes out and

...wont accept commands from remote or buttons on machine The problem is in the power supply board, often caused by a defective capacitor that becomes open, cap value is usually around 1000uf and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...