...VS-5041 TV but cannot locate the DIP SWITCH. Please advise. Jae i don't know about the dip switch, but the ir receiver board in this mitsu is located in front of the mirror behind the ...
Question about VS-60609 60" Rear Projection Television
...IR receiver. In either case I could only recommend a technician to disassemble the set and clean the mirror. As a technician, the mirror is the hardest surface to clean, because the silver is on the ...
...IR circuit is the one that receives the remote signal. About the original problem with the light blinking instead: If the TV goes in standby, then it is in protection mode. Ensure also that the fault ...
Question about WS-55711 55" Rear Projection Television
...me? Will the TV tunr on using the front panel power switch? Need to narow down the problem first. TV has IR receiver on the front panel to receive the signals from the remote, so it can be bad
Question about WS-55711 55" Rear Projection Television
...IR-receiver pcb. I was not able to ascertain a part# for this pcb, as the unit is over 10years old. There is,however, a part# printed on that pcb & you may be able to google that & locate the ...
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions