Questions & Answers for: Olevia ir receiver Cameras

Question about LT23HVX 23 in. LCD Television

1 Answer

...IR sensor Power Menu Channel down Channel up Volume + Volume - Source Rear Panel Features: 15-pin VGA Audio in Headphone Component Y, Pb/Cb, Pr/Cr Composite RCA video inputs S-Video Antenna Power ...

Ad

Question about LT37HVS 37 in. LCD HDTV

3 Answers

...sell the IR receiver I would buy it then replace it myself i have a remote control you can have it its not the remote mine works on a tv upstairs but not my Olevia tv its the tv found out last ...

Ad

Question about LT42HVi 42 in. LCD Television

1 Answer

...or manual. Sometimes the IR receiver on televisions refuse to read IR codes from the remote. Resetting the television by turning it off and unplugging it for a few minutes usually solves this

Question about LT27HVX 27 in. LCD Television

1 Answer

...IR receiver in the TV or the logic board. Testing remote control: The remote control puts out IR (InfraRed) signal that human eyes cannot see, to find out if the remote is sending out the signal or ...

Question about LT27HVX 27 in. LCD Television

2 Answers

...IR receiver in the TV. Testing remote control: The remote control puts out IR (InfraRed) signal that human eyes cannot see, to find out if the remote is sending out the signal or not you just point ...

Question about LT27HVX 27 in. LCD Television

1 Answer

...on the camera, then the problem is in the TV IR receiver or the main logic board; more troubleshooting with scope will be needed to look at the signals. Parts: www.shopjimmy.com ...

Question about LT27HVX 27 in. LCD Television

2 Answers

...IR receiver or the main logic board; more troubleshooting with scope will be needed to look at the signals. Parts: www.shopjimmy.com www.remotes.com Basic LCD monitor and TV troubleshooting guide: ...

...ir receiver replacement You may find this is impossible to do---the receiver if the set has buttons on front will be located there--if on same tiny circuit board as buttons you will have to TRY to ...

...IR data receiver is used, and its output is connected to a scope to see if the data is present. A crude way to see if a remote is at least emitting from its IR LED is to face a video or photo camera ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...