Questions & Answers for: NAD ir receiver

...is good as working with other devices by learning function. Must be something wrong with the reveiver. This was fixed by myself, the IR receiver was dead, replaced with a good one, working fine

...stand-by mode. Background: recently I had the receiver "ignoring" any input occasionally - either direct or through the remote. Thanks! Mor has 2 zener diodes and a 12 volt regultor defective in the ...

receiver in which the fuse blows every time I have replaced it. I even uplug the amp in the case that this is somehow causing the overload to the fuse. I'm assuming that one of the resistors is bad or

OVER HEAT My NAD T743 gives a message on the console "over heat". While this is happening the receiver stops functioning. I even can't stop the receiver. Could you give me advice. To reset the the ...

...happening when your speakers are disconnected, your problem is not in the receiver, it's either a wire touching at the terminals on the rear of the receiver, or a bad voice coil or crossover in your ...

WILL T-763 PLAY MY CD'S OR DO I NEED SEPARTE CD PLAYER? That's a receiver only, so its only built in function is the tuner. You'll need a separate CD player, plugged into the CD input jacks on the ...

...IR receiver window on T 754 is obstructed â?¢ T 754 front panel is in very bright sunlight or ambient light Troubleshooting tips ...

NAD T-763 receiver. cannot get surround sound. all speakers work. should the 7.1 and or surround be connected to the receiver and what else. stereo works fine....two front speakers, in stereo mode. ...

...does light up (red LED) when the buttons are pushed. It seems like a problem with the players IR reception. ANY suggestions? Is it in the path of strong direct sunlight at times during the day? ...

...and rear panels of the receiver and clearly shows that the turntable should be plugged into the pair of sockets on the left hand side (as you look at it) of the bank of 10 paired input sockets on ...