Question about Catalyst 4006 Chassis ( 4006)
...config will be as follows: Primary side interface vlan 20 ip address 192.168.1.1 255.255.255.0 secondary ip address 192.168.2.1 255.255.252.0 standby 1 ip 192.168.1.2 standby 1 priority 105 standby 1 ...
...config of vlan 8 and 2 interface Vlan2 ip address 172.16.0.1 255.255.255.0 ip helper-address 10.20.8.12 (dhcp server address ) interface Vlan8 ip address 10.20.8.1 255.255.252.0 # ip routing is ...
Question about Catalyst 2950 24x10/100 Mbps Networking Switch
...ip helper . in config mode. Just configure your 4 scopes on your DHCP server, and as long as your server is VLAN tagging and the trunk between the gateway and the switch is dot1q then it will
Question about Catalyst 2960 8-Port Ethernet Switch (WS-C2960-8TC-L)
...config-if)#ip address 172.225.18.100 255.255.254.0 ^ % Invalid input detected at '^' marker What am I doing wrong? you want to give IPs to your VLANs and also make physical interfaces members of a ...
Question about Catalyst 2960 8-Port Ethernet Switch (WS-C2960-8TC-L)
...IP address of the Cisco switch Enter the telnet access password for the Cisco swict when requested, and then the "Enter" key. Type "enable" at the command prompt, and then the "Enter" key. Enter the ...
Usually answered in minutes!
15 Questions
12 Questions
11 Questions
10 Questions