Questions & Answers for: Alcatel ip config

serial port 1 I was setting up the serial port for ip (ppp/ip) when i lost connection to it and now i can not access the serial port 1 with hyperterminal using the default settings. the second serial ...

Replacing dsl modem I have to replace my DSL modem that is connected to a router for my network.I do not want to install the ISP software. Can I just swap the modems as the router holds all the ...

DCC port problem-1 We use Alcatel Mainstreet 3600 Bandwidth Manager. We have DCC cards(V.24 RS232) installed for RTU data polling. For new RTUs we had to enable new DCC port. When we make cross ...

connect 3600 Alcatel over IP network we have large network of alcatel 3600 carry over SDH. in near future, we will move to IP network to carry voice and data. 3600 is good product carry tel and low ...

Dual E1-3 card say CArd Dead, because has been offen reset. Card Reset alarm declaration parameters is 3, 0, 103. I'm not find in Maintenance this third parameters (103). Help me resolve this problem.

network key for ot 800 How do I configure my NIC with a static IP for use with a SpeedTouch Home?If you are using an Alcatel SpeedTouch Home (without a router), a PPPoE client such as NTS, WinPoet, or

cant connect my phone to my vauaxhall insignia sri model it says on my manual to press config and phone settings should come up is there any chance i dont have this bluetooth but its a brand new 62 ...

Issue with time synchronizing(NTP) on layer 2 switch Server Reference ip is showing as 0.0.0.0 setup is: OS6850E ---> CISCO ------> NTP Server S-07SR-04A-05A-03A # show ntp status Current time: Tue, ...

...1.2.3.1 and config tftp addr 1.2.3.2 to set static IP parameters And then reboot the phone. Now it should connect to the OXE and get the new password. Check the link: reset 4068 to factory ...

...it opens the route 192.168.1.1 but the page remains blank, how can I solve it You have the right IP address. Does it belong to you ISP, or did you buy it secondhand, stolen from an ISP. They lock ...