...config)#ip address fo 192.168.1.1 255.255.255.0 !--- Assign an IP address. Failover Commands PIX(config)#failover ip address fo 192.168.1.2 !--- IP address for the failover link. PIX(config)#failover ...
...ip) Config dsp# voice 81 (for g723) voice 68 for (G729) Config# submit Local information Name of this zone Hello Country selection Canada Local country code country code (91) International prefix ...
Question about Catalyst 2960 8-Port Ethernet Switch (WS-C2960-8TC-L)
...config-if)#ip address 172.225.18.100 255.255.254.0 ^ % Invalid input detected at '^' marker What am I doing wrong? you want to give IPs to your VLANs and also make physical interfaces members of a ...
config-if)# ip address 10.91.24.5 255.255.255.0 ASA5505(config-if)# no shut ASA5505(config)# interface Vlan 2 ASA5505(config-if)# nameif outside ASA5505(config-if)# security-level 0 ASA5505(config-if)
config-if)#ip address 1.1.1.1 255.0.0.0 Router(config-if)# no shutdown2.Create a DHCP IP address pool for the IP addresses you want to use. Router(config)# ip dhcp pool mypool3.Specify the network and
x y.y.y.y where x is your IP address you wish to have and y is the subnet mask example below: router#config t router(config)#int f0/0 router(config-if)ip address 10.0.0.1 255.255.255.0 hope this helps
Question about 3845 Integrated Services Router (C3845VSECK9) Firewall
...1 native Hostname(config-if)#ip address x.x.y.y < subnet mask > interface FastEthernet0/1.2 Hostname(config-if)#encapsulation dot1Q 2 Hostname(config-if)#ip address x.x.y.y < subnet mask
...config page with the ip address on a imagerunner 5570 To print a config page you go into service mode (*28*) -copier>option>p print this will print out all the configs. For just the ip address ...
Question about PowerConnect 3548
config-if)# ip address 10.10.90.222 255.255.0.0 console(config-if)# ip http port 80 console(config-if)# ip default-gateway 10.10.90.1 console(config-if)# ip http authentication none console(config-if)
...config)# ip default-gateway 192.168.1.254 Console(config)# To configure the switch for DHCP or BOOTP: From the Privileged Exec level global configuration mode prompt, type interface vlan 1 to access ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions