...Torque intake manifold: Step 1: 12 inch/Lbs, (hand tight) Step 2: 72 inch/Lbs, (6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: ...
Need torque sequence and torque specs for intake plenum on 3.5L 02 Olds Intrigue. bottom intake bolts torque 15-18 ft lbs from center and in criss cross pattern top plenum bolts 12-14 ft lbs
...Intake Bolt Torque... Tighten in 3 steps: Step 1: 7.5 FT Lbs Step 2: 15 FT Lbs Step 3: 24 FT Lbs(to torque bolts & nuts, start in center using crisscross pattern) Hope helps (remember to rate and ...
Question about 1998 Mustang
How do i Torque the intake manifold on a 4.3 mercruiser engine. Torque pattern and torque setting Circle pattern center out 15 lbs 35 lbs finish 65 lbs
Question about 1998 Mustang
torque sequance for the intake manifold on a 2004 hyundai xg350l what is the torque sequence for the intake manifold on a 2004 3.5L Hyundai XG350L? here is the torque pattern and the torque spec is 14
...intake torque spec. and tighten sequence on upper intake starting at the middle bolt and go directly across then criss cross the pattern like you would tightening wheel nuts, towards the outside(end) ...
Question about 2002 Grand Am
...torque spec and intake manifold torque spec and pattern need torque procedure on rocker arm bolts and also on the intake manifold and what pattern to tighten them in 3.4 6 cylinder I could not answer ...
Question about 2001 Explorer Sport Trac
Intake bolts torque pound and pattern to torque them ford 2001 sport trac SOHC Intake Manifold Torque Specifications
Question about 2003 Intrepid
...torque. Upper Intake Plenum: When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be ...
Question about 2003 Intrepid
torque values for the 2008 Sorento 3.3 engine intake manifold and middle flash? Criss-Cross pattern ends to centre. INSTALLATION Install intake manifold and new gasket on the cylinder head. Tightening
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions