Questions & Answers for: Dodge Intrepid intake plenum torque

...intake plenum. This device has the upper radiator hose connected in front, and the tube which runs back below the intake plenum connects to a heater hose at the rear. The hose clamp on the rear ...

in gear it dies Could be a problem with the lockup clutch in the torque convertor. Might also be a problem with a leak in the intake plenum (hose) between the mass airflow sensor and the throttle body

...Intake plenum, lower intake manifold and exhaust manifold Valve and timing chain covers Coolant connections for the cylinder heads Rotate the crankshaft until the crankshaft timing mark aligns with ...

location of air intake temp sensor 2001 intrepid... Location of air intake temp sensor 2001 intrepid intake plenum

...intake plenum above the throttle body.but On the 3.2/3.5ltr engines it is on the rear drivers side of the plenum.Both engines have hoses attached going to the drivers side valve cover hope this ...

...intake plenum. Are these engines known to pull oil vapor into the plenum through the pcv system. Also, looking for a diagram on how the butterfly valves are configured inside the plenum as they need ...

...intake plenum.  I think pretty much anyone who has a license to operate a screwdriver can handle the job.  It is fastened to the plenum with a single screw.  Disconnect the electrical ...

...simple body why when i hook brake booster vacum to plenum does engine die. i had plenum and intake off could it be leaky gaskets yes most likly a pinched gasket or pluntuym not sittin=g down ...

...Intake Plenum: When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be torqued to 250 ...

...intake I have a 04 intrepid with a 3.5L HO engine. My plenum has an electric motor in the front of it and the one I got from eBay does not have that or the flaps inside of it what is the differences ...