Questions & Answers for: Chrysler Sebring intake plenum torque

Question about 2004 Sebring

1 Answer

How do you get to back spark plugs How do you get the back spark plugs on a 2004 Sebring Convertible You'll need to remove the intake plenum. From there you can access the plugs and wires.

Ad

...intake plenum. After completing all of this the car now runs fine when it is cold, but when it warms up (to normal operating temperature.) the car will not idle smoothly and when you go to accelerate ...

Ad

...these (If open) will not work....they run very hot and are cooled by placing them in the fresh air intake of the plenum. Replacement is best....parts house may have them. If not, try Junque

Question about 2002 Sebring

2 Answers

...gasket on the lower intake manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm) Hope helps (remember to rate this answer). Good job. 105 inch pounds 11.8 newton meters 8.7 foot ...

...TORQUE SPECS FOR THE INTAKE MANIFOLD BOLTS ON A 2001 CHRYSLER SEBRING 3.0L ENGINE Sorry first attempt got sent by accident Upper intake manifold bolts/nuts 168 in-lbs Lower intake manifold nuts are ...

torque about what component (cylinder head, intake-exhaust manifold, etc). If you buy a Chilton manual at your local parts store for that year of vehicle, it will list all of the torque specs for your

Question about 2001 Sebring

1 Answer

...intake plenum to get at one of the bolts that hols it in place. Its not that big of a deal to remove. Just remember to replace the plenum gasket and torque the bolts to the proper spec. If you have ...

in need the torque for the bolts to the plenum the bolts that go into the plenum to the lower intake theres 7 bolts and they need to be torqued intake manifold upper and lower 89 in. lbs.

Question about 2000 Sebring

1 Answer

intake plenum. Remove plenum and re install with new gasket later (It's easy). Take your new plugs and make sure thy are platinum or better and gap them for your engine.Put antiseze on the threads

...intake or plenum is $400 and the instal is about 30 minutes to 1hour if that! You can only get the part from the dealer if you want i will be replacing one in the next couple days i can send a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...