Questions & Answers for: Saturn intake plenum torque

...to tell is look on the intake plenum and see if there is a "carb" sitting there. That's tbi. Intake plenum with 4 or more fuel lines going to each cylinder is a "MPI" (multiport) ...

...intake manifold torque sequence illustration. The illustration is located after the Torque Specification Chart. Install or connect the following: New gasket and manifold. Torque the nuts in sequence ...

...it could have loose intake plenum bolts inside the intake causing a internal leak,,,and or a mass air flow sensor,but not a standard intake leak ,there is a tech service bulletin for this at ...

...intake plenum -- you first have to drain the coolant then remove the intake plenum -- you may have to lift the engine with a floor jack to allow extension housing to be removed from radiator - remove ...

Torque the intake and exhaust camshaft sprocket bolts; torque as follows: First Pass: 63 lb-ft. (85 Nm) Second Pass: Turn an additional 30° using a torque angle gauge Install the sealing ring and

...intake plenum, then the lower intake. Remove the hose from the thermostat inlet housing. Remove the bolt that holds the extension housing to the head near the oil dipstick. Carefully jack up the ...

...INTAKE SIDE 8 4 1 5 9 7 3 2 6 10 EXHAUST SIDE In sequence, torque the cylinder head bolts. Torque: 30 Nm (22 ft-lbs). In sequence, torque all bolts. Torque: 50 Nm (37 ft-lbs) In sequence, turn each ...

torque specs for 2004 saturn intake manifold 3.5 Torque sequence on a intake 16ft lbs starting at center and working outward, alternating tightening evenly

...intake air plenum is tight(hose clamps) check the MAF sensor. After the check the fuel pressure regulator. This will dump gas into the intake also. After that go for the injectors. Stuck open will ...

...intake plenum bolts. Remove the EGR passage bolt. Rotate the plenum up and remove the throttle body coolant hoses, EVAP hose, and vacuum line from the throttle body. Remove the throttle body nuts. ...