6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs (To torque bolts, start in center using crisscross pattern
in gear it dies Could be a problem with the lockup clutch in the torque convertor. Might also be a problem with a leak in the intake plenum (hose) between the mass airflow sensor and the throttle body
...Intake plenum, lower intake manifold and exhaust manifold Valve and timing chain covers Coolant connections for the cylinder heads Rotate the crankshaft until the crankshaft timing mark aligns with ...
...intake plenum (the very top silver box under the hood). An easy way to check is to see if the enigne will start in neutral as well as park. If it doesn't, adjust the linkage. Next, right behind the ...
...intake plenum. If engine was cranked while distributor was removed, establish proper relationship between distributor shaft and No. 1 piston position as follows:Rotate crankshaft until number one ...
Question about 2003 Intrepid
...Intake Plenum: When installing the intake air plenum , be sure to catch the four center bolts and the two side bolts (stiffener brackets) before tightening , The center bolts should be torqued to 250 ...
dodge caravan 2009 4L intake plenum torque what is the plenum torque Tighten bolts gradually starting in the center working outward until a torque of 12 Nm (105 in. lbs.) is obtained.
Question about 2003 Intrepid
Installing upper intake plenum 2007 dodge charger 3.5 and need bolt torque requirement Torque the intake plenum bolts to 88 inch. lbs. (10 Nm).
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions