Questions & Answers for: intake manifold gasket replacement

...intake manifold have coolant pasages. The lower intake manifold gasket will need to be replaced. There is an updated manifold gasket, manifold bolts, and torque specification. Call the chevrolet ...

...intake manifold is leaking. People at work indicated that the problem with the GM lower intake manifolds is that the manifold warps causing the gasket to leak, not so much a gasket problem. They ...

intake manifold gasket / replace guide to replace intake gasket on 1998 olds bravaca 3.8L Engine NOTE The 3.8L (VIN K) non-supercharged engine uses a two-piece intake manifold consisting of an upper ...

...INTAKE MANIFOLD ON A LINCOLN HOW DO I REPLACE THE INTAKE MANIFOLD ON A 1999 LINCOLN TOWNCAR? answer , very carefully ... drain coolant , remove and mark all vacuum lines , make a schematic to diagram ...

...intake manifold gasket My 1996 land rover discovery is acting funny. It is driving fine, but the intake manifold gasket keep sweeling under the intake. What is causing this? oil from the pcv valve ...

...intake manifold 3.8L Engine (most common)Upper Intake ManifoldTo Remove: Drain the cooling system. Remove or disconnect the following: Negative battery cable. Fuel injector sight shield. Air cleaner ...

...intake manifold gaskets. If you have inline (4-cylinder), the cause may be intake gaskets or bad or unhooked vacuum hoses attached to the intake manifold. Check all vacuum hoses for cracks or loose ...

...intake manifold supports.8. Remove support brackets at the intake manifold front corners and MTV.9. Loosen upper fastener attaching throttle body to support bracket.10. Remove clips attaching EGR ...

...intake manifold and manifold gasket. Disconnect the throttle body inlet duct from the engine. Twist off the radiator cap to allow draining of the coolant to flow more smoothly. Place an empty ...

...Intake Manifold Gasket? I must removed at least part of the intake manifold . Will I need a new Gasket ? If you have to remove the top half or plenum of the intake manifold, it is always recommended ...