Questions & Answers for: Toyota 4Runner intake manifold

...intake manifold assembly must be removed to access the starter motor and solenoid. (Toyota calls the solenoid a "magnetic switch.") Except 2UZ-FE Engine Fig. Unfasten the starter mounting bolts . . . ...

...intake manifold,1995 toyota 4 runner water leak under the intake manifold, 1995 toyota 4 runner There is a heater core bypass pipe that runs from the block (under the manifold) to the bacl of ...

...intake gasket manifold in a 1994 Toyota 4runner. Do you know where I can get that information? The pressure regulator should be fitted ot the fuel rail firewall end and the inlet manifold gasket on ...

...intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if you have a/c, remove harmonic balancer ,remove timing belt ...

...intake manifold that has a short hose attached looping back on to a fitting on the backside of the manifold. The tube goes down and toasted the front oof the engine under the intake manifold. Where ...

...have of these have a hand in the problem? and what might be the problem? That sounds like an air leak in the intake manifold area. If there is no hose off,it could be a intake manifold gasket ...

knock sensor location V6 model? If so, knock sensor is under intake manifold. You will have to remove intake to replace.

...a 4.7 2003 4 runner its under the manifold Big job......you need to remove upper intake manifold it is just under ilt, new gaskets a plus and get a factory replacement unless you want to do it

...intake manifold torque specifications on a 2005toyota solara with a 3.3 engine i wanted to know before i start working on my car i went on line to find the answer but it was not available for some ...

...intake manifold located at"? It is the top of your motor where your throttle tube connects to the engine..it covers all six cylinders to get air to them...basicly there are three main parts of an ...