Questions & Answers for: Ford Crown Victoria intake manifold

...INTAKE MANIFOLD BLEW OUT AND WATER WENT EVERYWHERE...FORD SAID MY MODEL WAS NOT IN THE RE-CALL IT IS A PLASTIC MANIFOLD...THANK YOU yes have replaced several plastic intakes due to coolant and vacuum ...

...INTAKE MANIFOLD TO THE CENTER OF THE ENGINE AND IS WHY YOU CANT SEE WHERE IS COMING FROM BECAUSE THE ANTIFREEZE RUNS TO THE BACK I RECOMEND TO CHECK THAT AND USUALLY YOU HAVE TO REPLACE GASKETS AND ...

...intake manifold, modern fuel injected cars and trucks (gas engiones) have a upper and lower intake manifold, the upper section is called the plenum. It is the upper intake that looks like aluminum ...

...intake manifold. It's either coming from the hoses or there is a leak in the tubing coming from the intake manifold to the hoses connecting to the heater core. How would we remove the tubing rail? ...

...intake manifold.  Under the airhorn, and under its gasket is a channel which needs to be cleaned for top performance.It takes a $10 gasket, and about 1 hour of time to pull and replace the ...

...Intake Manifold, now Crown Vic won't start Had the intake manifold blow out on the freeway (and this was the new one with the aluminum cross-over). I installed a new intake manifold, but now the ...

...intake manifold now check engine light on Had intake manifold replaced and now check engine light flashing and hesitation in accelerating. You don't want to use a car with a flashing check light On a ...

...is antifreeze in the spark plug hole,you may have a bad intake gasket or cracked intake manifold and the antifreeze is shorting the coil out. In that case you may have to replace the intake

...good intake manifold for my car Intake manifold is one thing its a combination of thing cam shaft with intake manifold if you simply change the intake and youdont have the cam that goes with it no ...

...intake manifold, via a nipple, and that is connected yet another plastic piece inside the I.M., that is where my leak is? Can I replace that part, or do I have to replace the whole intake manifold? ...